0

Out of 0 Ratings

Owner's of the Celestron Telescope NexStar HC gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 53
 
8
The NexStar 4 comes completely pre-assembled and can be operational in a matter of minutes. The NexStar is conveniently
packaged in one reusable shipping carton that contains all of the following accessories:
25mm SMA Eyepiece – 1
¼
"
Star Pointer Finderscope and Mounting Bracket
The Sky® for Celestron Astronomy Software
A
A
s
s
s
s
e
e
m
m
b
b
l
l
i
i
n
n
g
g
t
t
h
h
e
e
N
N
e
e
x
x
S
S
t
t
a
a
r
r
Start by removing the telescope from its shipping carton and setting the round base on a flat table or surface. It is best to
carry the telescope by holding it from the lower portion of the fork arm and from the bottom of the base. Remove all of the
accessories from their individual boxes. Remember to save all of the containers so that they can be used to transport the
telescope. Before the batteries can be installed, the telescope tube should be positioned horizontal to the ground. To do this,
gently rotate the front of the tube upwards until it is level with the ground.
Powering the NexStar
The NexStar can be powered by eight AA batteries (not included), an optional 12v AC adapter or an optional car battery
adapter. The battery compartment is located in the center of the telescope's base (see figure 3-1).
To power the NexStar with batteries:
1. Remove the battery cover from the center of the base by
gently lifting up on the round portion of the cover.
2. Insert the batteries into the battery compartment of the base.
3. Reattach the battery compartment door by gently pushing
down on the cover until it snaps into place.
4. Turn on the power to the NexStar by flipping the switch,
located at the base of the fork arm, to the "On" position.
Battery Compartment
Cover
Figure 3-1: The NexStar 4 Battery Compartment