ATN Binoculars Night Shadow User Manual

0

Out of 0 Ratings

Owner's of the ATN Binoculars Night Shadow gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 12
 
2
APPLICATION
The Night vision Biocular is a complex opticoelectronic system for individual use. The device
consists of the objective lens, eyepiece and body. The body contains either a 1st + GN or a 2nd
+GN intensifier tube assembly with an integrated high voltage power source and two three-volt
battery housing. When installing the batteries one should keep in mind that the polarity of the
batteries must coincide with the diagram on the body next to the battery housing cap.
The objective lens protective cover is designed to protect the objective lens from dust and
scratches. It also acts as a daylight filter allowing you to test the Biocular in the daylight or other
bright light situations. The pinhole in the center of the protective cover allows the user to check
the operation ability of the device under the daylight conditions.
NOTE: Do not test the scope under the daylight conditions even with the daylight filter/lens
capon for more than ten (10) minutes.
SMART DIGITAL TECHNOLOGY
Smart Total darkness Technology finally provides the user
total control in the hi-tech industry of night vision. The
Smart Series night vision monoculars have been designed
with the latest computer technology. On board computer
systems identify the users intention of looking through the
oculars. When the ocular is brought to the users eyes, the
monocular will automatically turn on. When removed from
the eyes the monocular will turn off ( you must engage the
proximity sensor for this feature to work) . The user will
never have to worry about turning his or her monocular on
or off. Smart series monocular automatically sense when
it is no longer being used, and will shut off and enter their
sleep mode. All the controls and buttons are digital. Even
if your batteries are low, don’t worry the smart series will
let you know.
To use the smart sensor of the Night Shadow and save the life of the scope as well as your
batteries, press both the “SL” key and the “+” key. The Voyager will now turn off when you move
away from the scope. It will turn back on when you move back to the scope.
1. ON/OFF indicator light - when power is ON, the LED will be green.
2. When the proximity sensor is activated the LED changes to red.
3. When IR is ON the LED is orange.
NOTE: You may notice the persistent green glow for up to five (5) minutes after you have turned
the unit off. This is normal for the 1st Gen. light intensifier tube.

   Find Your Products By Category